Wind Turbine

Model of a wind turbine made to scale. The tower is made in two pieces so that it fits within the printing volume of the X1C. A connector has been added to the tower so that when joining it it is perfect. At the junction of the tower with the Nacelle the connector has been made round, leaving it up to you whether you want to stick and leave it immobile or whether it can rotate. The blades have been made separate from the hub so as not to have to put supports and, in theory, they have enough margin for them to fit well, although it depends on how you configure the seam, you may have to go over it a little with sandpaper, I only had to sand a little one of them. The union of the hub with the Nacelle has been designed to fit under pressure, allowing the blades to rotate. At this point it is convenient to sand the base of the hub a little if you notice that it rubs something, here simply sand a little to allow a slightly smoother movement. NOTE: you will see that in the Nacelle, on the sid