Slicer Discord
Wind Turbine V5 – 3D-Druckmodell von Thingiverse Thingiverse

Wind Turbine V5

von _Maxim3D_
186 Downloads
116 Likes
0 Makes
Zum Modell
YOUTUBE : https://www.youtube.com/watch?v=8jUuHAaTOZA

I have build this turbine with the objective to produce electricity to charge small devices like smartphone or powering a led strip.
I can't use solar panel because my balcony is lit by the sun 4 hours per day. But luckily for me, i live near the sea and there is constant wind which coming with the tide, so i decided that building a wind turbine can be a good alternative.

This wind turbine is pretty reliable and robust, it survive many storms (wind > 110km/h !) with little damage (some nuts tend to loosen, they were remplace by nyloc).

This wind turbine starts with wind speed of 3m/s (approx .10km/h) with no load.
The measured torque on the shaft is approximately 0.25N.m at 20km/h wind. I think is sufficient to move a stepper motor to produce some electricity but it will increase the wind speed at which the turbine starts.

I am using stepper motor from Digikey (ref 1528-1062-ND) as generator and a full bridge rectifier
Quelle
Thingiverse
Was du zum Drucken brauchst: Mittel Niedrige Konfidenz
Einteilig Hardware nötig
Supports 1/3
Zusammenbau 0/3
Einstellungen 1/3
Druckbett 0/3
Nachbearbeitung 1/3
Drucker
FDM / FFF
Dateiformat
STL
Material
PLA
Ca. Druckzeit
4 h
Nachbearbeitung
Hardware
Software
Cura, PrusaSlicer o. Ä.
Noch keine Bewertungen
Noch keine Kommentare – sei der Erste!
Feed Blog Slicer Kostenrechner Bildersuche Einreichen Kontakt Discord ☕ Buy me a coffee
DE EN FR ES IT NL

Zur Sammlung hinzufügen