Thingiverse
Window Tilt Latch
door Rxich
2
Downloads
2
Likes
0
Makes
The OEM made a very poor choice. The OEW latches essentially disintegrated to dust. The plastic became very brittle exposed to the sun. This part is a perfect match, thanks to my engineer son-in-law. The screw holes are 2 1/8 inches on center
Each part took about an hour to print. I run my Ender at 130mm/sec(yes I know it's ill advised, but it works great)
Each part took about an hour to print. I run my Ender at 130mm/sec(yes I know it's ill advised, but it works great)
Heb je dit model geprint? Inloggen en deel je make!
Log in om een reactie achter te laten
InloggenNog geen reacties – wees de eerste!