Thingiverse
Windsock Truck Bed Mount
by grantges
0
Downloads
1
Likes
0
Makes
I designed these mounts to support a 19' windsock from my Ford F-150 truck bed, using the pre-existing half inch holes near the gate.
There are two different mounts for the top hole and the bottom hole to accommodate the tapered windsock.
The design allows you to push the mount into the hole and currently its meant to be permanent as. you have to just break the mount to remove it at this point. I may upload an update that allows for a more removable mount.
If you have suggestions on how to make this better - please leave comments! Always looking to improve my designs :)
Windsock Pole:
https://www.amazon.com/dp/B001JNJNXW?ref=nb_sb_ss_w_as-reorder_k2_1_13&=&crid=2PDC6PVZB4DTX&=&sprefix=windsock+pole
There are two different mounts for the top hole and the bottom hole to accommodate the tapered windsock.
The design allows you to push the mount into the hole and currently its meant to be permanent as. you have to just break the mount to remove it at this point. I may upload an update that allows for a more removable mount.
If you have suggestions on how to make this better - please leave comments! Always looking to improve my designs :)
Windsock Pole:
https://www.amazon.com/dp/B001JNJNXW?ref=nb_sb_ss_w_as-reorder_k2_1_13&=&crid=2PDC6PVZB4DTX&=&sprefix=windsock+pole
Did you print this model? Sign in and share your make!
Sign in to leave a comment
Sign inNo comments yet – be the first!
