Thingiverse
Wine rack support
di Joepro19
0
Download
0
Likes
0
Makes
Made this to hold my wine rack vertically. (see pdf for picture) Could also work to hold it horizontally.
I made 2 to make sure it would be solid enough to hold the weight. Been holding up for almost 6 months. Be sure to load the rack from the bottom.
Printed on the side without support (see picture)
Printed in PLA infill 100% but could be stronger in PETG.
I made 2 to make sure it would be solid enough to hold the weight. Been holding up for almost 6 months. Be sure to load the rack from the bottom.
Printed on the side without support (see picture)
Printed in PLA infill 100% but could be stronger in PETG.
Hai stampato questo modello? Accedi e condividi il tuo make!
Accedi per lasciare un commento
AccediAncora nessun commento – sii il primo!
