Thingiverse
Wingnut Socket 3_8 Drive
door Hoboeraser
2
Downloads
4
Likes
0
Makes
This tool was born out of necessity. I made it so that I could adjust the belt tension wingnut on my car without having to pull half the engine apart and remove the tire to reach in and adjust one of my belts. The tensioner was right in the wrong spot to be able to adjust it by any sane fashion and I don't have a floor jack to pull it all apart. So I came up with this tool.
It fit's a 3/8 in drive socket and bites down well enough on the wingnut to be able to give the belt the tension it needs and wont slip off as easily.
I recommend printing it WITHOUT supports. they can be a pain to remove from the socket hole.
It fit's a 3/8 in drive socket and bites down well enough on the wingnut to be able to give the belt the tension it needs and wont slip off as easily.
I recommend printing it WITHOUT supports. they can be a pain to remove from the socket hole.
Heb je dit model geprint? Inloggen en deel je make!
Log in om een reactie achter te laten
InloggenNog geen reacties – wees de eerste!
