Thingiverse
Wingspan Resources
von greendog99
374
Downloads
188
Likes
5
Makes
I recreated GregNetDesign's beautiful Wingspan resources in Fusion 360, with a couple changes:
1) The pieces are thinner, about 1/2 the thickness of the originals (faster printing, less filament)
2) The grooves are deeper, making them more pronounced.
3) The pieces are two-sided, which most printers should handle just fine with bridging.
4) I designed a different "Berry" resource from scratch.
Note: because there are now grooves on the bottom as well as the top, it's extra important to have good printer settings for first layer adhesion and for bridging. A level bed, a slow first layer, and no elephant foot compensation are suggested, especially for the worm where the first layer is multiple separate pieces.
1) The pieces are thinner, about 1/2 the thickness of the originals (faster printing, less filament)
2) The grooves are deeper, making them more pronounced.
3) The pieces are two-sided, which most printers should handle just fine with bridging.
4) I designed a different "Berry" resource from scratch.
Note: because there are now grooves on the bottom as well as the top, it's extra important to have good printer settings for first layer adhesion and for bridging. A level bed, a slow first layer, and no elephant foot compensation are suggested, especially for the worm where the first layer is multiple separate pieces.
Hast du dieses Modell gedruckt? Einloggen und dein Make teilen!
Melde dich an, um einen Kommentar zu hinterlassen
AnmeldenNoch keine Kommentare – sei der Erste!
