Wingsuit Model Rocket

No parachute needed (Nor will one fit)
A-C Motors may be used

I just used a little bit of super glue and cut a long rubber band in order to secure it on the inside, the nose cone has a hole in the bottom that you may thread a zip tie through to be used as a tie on point

I've tested this and it works super well!

While using a C motor be sure that the winds are calm and you are located in a very large open area, I've found that when a C motor is used the rocket can go out of view very easy, for this reason bright colors might also be helpful

Here's a video on a google drive to watch it!
https://drive.google.com/file/d/17nEWG-0ZPnecG5BrXbLE7ATjFoLJXcgF/view?usp=sharing

Post Printing
After you take the print off of the build plate use some clippers or scissors to remove the circles on the ends of the wings, they are just there to prevent warping and provide a better adhesion in that area

Update (2/26/23)- Changed the wing supports to be more aerodynamic and stronger