Winterdecoration

Careful, it is pointy as the original.
(The sensation felt when overcome a certain pressure point is almost identical painful)

This is an easy print.

No supports needed.

I printed this with a .25 nozzle and a layer height of .150
Around 3,5 hrs and roughly 16gram.

Cooling increasingly to the top would be good.
I printed it this way, not sure if it was needed though.

In between the "branches" are small balls for decoration.
Just accept the challenge to paint them :)


/////////////////////////////////////////////////////////////////////////////
Updates
/////////////////////////////////////////////////////////////////////////////
//edit 2018-12-11:
-added Variante3.5, prints easy without any support but needs cooling.
Has a 5mm hole in the middle of the base, fits appropriate LED-tealights.

-added Variante1 & Variante2


//edit 2018-11-29: added "V2", it is without the balls in the branches, if you like the model for a diorama or such...
//////////////