Wire beak holder

#Beak for wire holding.

> I remixed this **wire beak** (original beak design by charlesmouse for his Wire Bird) to go with Cybertron3D's third hand solder helper. *8.25mm sphere* and fits directly into the female cup. I remixed it because I found it was impossible to print the original version without any supports. You print this standing up. *Print slowly* to get the first layer adhesion as it's a small area. I had my first layer printing at 5mm/s because it's PETG and the filament is sticky and tends to want to pull. You can probably print this faster in PLA.

>It's not meant to replace the crocodile clips but in COVID-19 times, you might need something printed to use immediately instead of waiting for an order to arrive.


### Thanks for looking and using this!
### If you like my design, and are feeling generous, feel free to leave me a ***tip***!
### Check my page out often for ***more designs*** as I continue to create and design stuffs!
# Happy **3D-ing!**