Slicer Discord
Wire clip organizer – 3D-Druckmodell von Thingiverse Thingiverse

Wire clip organizer

2 Downloads
4 Likes
0 Makes
Zum Modell
This clip grabs onto a shelf that is 13mm or .5 in wide, and hides/guides a cable.

I use it to hide the ugly cables from the router as they go down the back of an open cube shelf.

Just give the open end a squeeze, that'll open the wire side, grab the wire, then just slide it on the shelf back.
Quelle
Thingiverse
Was du zum Drucken brauchst: Anfänger Niedrige Konfidenz
Einteilig
Supports 1/3
Zusammenbau 0/3
Einstellungen 1/3
Druckbett 0/3
Nachbearbeitung 0/3
Drucker
FDM / FFF
Dateiformat
STL
Material
ABS
Software
Cura, PrusaSlicer o. Ä.
Noch keine Bewertungen
Noch keine Kommentare – sei der Erste!
Feed Blog Slicer Kostenrechner Bildersuche Einreichen Kontakt Discord ☕ Buy me a coffee
DE EN FR ES IT NL

Zur Sammlung hinzufügen