Wire Guard / 3D Printer Tangle Protector FLSUN Q5

If you're using a delta 3D printer, chances are that the plastic feed gets stuck in the rod-end joints. In my case(Flsun Q5), it causes the belt to skip(see [link](https://1.bp.blogspot.com/-UyRvdiQEAfg/Xxb3tdM3SjI/AAAAAAABxgE/JuLfhfuw8QkFXtLgMXIKcEvXgV4FBn1IgCK4BGAYYCw/s320/Q5CableSnap.gif) ), and well, there goes your print.

This is a simple cover for those rod-end bolts that prevents the catching of wires/plastic feed tube on the bolts

Printing:
Infill- 10-20%
Letters - No support needed
Holes - support required. Either snap out supports or drill using appropriate drill size to match bolt head size. I used a 5.5mm sized drill.
Material - PLA red