"Wire" keycap puller for mechanical keyboards

This is a keycap puller that will work for a variety of keyboards (mainly mechanical or topre). Use it to remove keycaps in order to swap them or clean your keyboard.

Here is a guide to assembling the keycap puller: https://imgur.com/a/M9XAp. You will need at a minimum 2 large paperclips and some glue.

With regards to 3D printing the file, there are only three things I can think to point out. The first is that there are four 1.25mm diameter holes in the part. Your printer should be able to bridge over them and I recommend against including support for them. The second is that if you print it upward-facing (as it is oriented in the .stl), you will likely need support for the part in the front that is at an incline. The last is that there is no bevel/chamfer so it may feel a little sharp in your hands.

[EDIT 3/23/16: As a reminder, please utilize caution and common sense when you use this keycap puller. Improper use could result in damage to your keyboard, so please refer to a u