Thingiverse
WIre Shelf Riser Clip - CR10S
door cheekybastard
0
Downloads
1
Likes
0
Makes
Settings aren't too important. I kept infill around 15-20%, adjusted wall and top/bottom layer to get around 1mm-1.2mm thickness.
This parts meant to raise the printer about 2 inches and clip onto commercial wire shelving and cradle the printer feet.
This parts meant to raise the printer about 2 inches and clip onto commercial wire shelving and cradle the printer feet.
Heb je dit model geprint? Inloggen en deel je make!
Log in om een reactie achter te laten
InloggenNog geen reacties – wees de eerste!
