Thingiverse
Wire Shelf Support (30 Degrees)
by denos
6
Downloads
6
Likes
0
Makes
Our house had a bunch of 30 degree wire shelves but the original support design was weak and several have broken over time.
This is my attempt at creating something stronger. It's basically an I-Beam that has been rounded to print without supports. The I-Beam also supports both faces to prevent them from fracturing along the center line (the most common failure point).
This is my attempt at creating something stronger. It's basically an I-Beam that has been rounded to print without supports. The I-Beam also supports both faces to prevent them from fracturing along the center line (the most common failure point).
Did you print this model? Sign in and share your make!
Sign in to leave a comment
Sign inNo comments yet – be the first!
