Wire spool holder

I had a wire spool lying around and wanted a designated cool place for it, so i designed a holder. It has two holes for screws, although it holds perfectly fine with just one screw. You could also just stick a two-sided tape and it should also hold.

I made the screw to test and replace the clip without the need to print the whole thing.

I suggest to print the holder on the side, with the screw up, it doesn't need supports.
The screw-on needs support inside.

You might have to heat the joint of the clip and bend it a bit for comfort.

It was designed pretty quickly, without much thought so feel free to suggest some changes.