Thingiverse
Wire tunnel
von PickyBiker
17
Downloads
11
Likes
0
Makes
This is designed to hide a wire inside a small tunnel.
I printed it with ABS because I am using them outside. It needs a raft extended about 8mm.
I printed it with ABS because I am using them outside. It needs a raft extended about 8mm.
Hast du dieses Modell gedruckt? Einloggen und dein Make teilen!
Melde dich an, um einen Kommentar zu hinterlassen
AnmeldenNoch keine Kommentare – sei der Erste!
