Thingiverse
Wired SRM Power Sensor Case
von Bug2k16
1
Downloads
2
Likes
0
Makes
Case to house the power pickup sensor under the bottom bracket and speed sensor case to house the pickup for wheel rotation.
Use a small amount of glue to hold the part in place inside the case. Glue cap on and around where the cable come out to seal it from any water ingress.
I also attached a small rubber pad to the base of the speed sensor to stop it moving when attached to the stay with cable ties.
Use a small amount of glue to hold the part in place inside the case. Glue cap on and around where the cable come out to seal it from any water ingress.
I also attached a small rubber pad to the base of the speed sensor to stop it moving when attached to the stay with cable ties.
Hast du dieses Modell gedruckt? Einloggen und dein Make teilen!
Melde dich an, um einen Kommentar zu hinterlassen
AnmeldenNoch keine Kommentare – sei der Erste!