Slicer Discord
Wireless charger dock – Modelo 3D imprimible de Thingiverse Thingiverse

Wireless charger dock

1 Descargas
0 Likes
0 Makes
Ver Modelo
Wireless charger dock for smartphone.

Tested with a S20+ with a OtterBox Defender case (increaste the height a little bit), but can be used with other Samsung models.

The wireless charger I used is the IKEA LIVBOJ and an IKEA Usb C-C cable, I don't know if it can fit other wireless chargers/charging cables, so i just increaste the width so it may fit with other USB C cables.

I have made the measurements from a previous version that I have printed and I had to adjust them because they were too small to put the charger and cable so this version can be either large or a little tight for the wireless charger to be embedded and avoid play or can be detached when not charging.

If you see that the hole where the wireless charger is placed is too tight, you can sand it with 200 grit sandpaper or less to reduce and adapt it to the right size (do not sand it too much or the charger may be too loose.

The bracket on the back is a different size from where it fits on the base, so you
Fuente
Thingiverse
Lo que necesitas para imprimir: Intermedio Baja confianza
Pieza única
Soportes 1/3
Ensamblaje 0/3
Ajustes 1/3
Tamaño de cama 0/3
Postproceso 1/3
Impresora
FDM / FFF
Formato de archivo
STL
Material
PLA
Postprocesado
Lijado
Software
Cura, PrusaSlicer o similar
Aún no hay valoraciones
Aún no hay comentarios – ¡sé el primero!

Modelos similares

6 Sugerencias
Feed Blog Slicer Calculadora Búsqueda por imagen Enviar Contacto Discord ☕ Buy me a coffee
DE EN FR ES IT NL

Añadir a colección