Wireless charger module enclosure

16.4.2020 update:
Changed size with a bit more inside height to improve cooling
Added spacer to center for lifting coil more up closer to surface
Top plate is in area of coil thinner
Added venting hole for warmer portions of board near connector
Whole edit caused bit stretch in Y axis, so you probably will need a slightly longer screw, ideal is 6.5-7mm of M2.5 screw with square nut.

This is a simple two part enclosure to many wireless charger modules obtainable from everywhere, if you are about to build one for yourself print those two parts, fit inside with some glue or tape possibly, then screw together through PCB with M2.5x7 screws to square 2.5 flat nut.
Here can be done a bit more work on header with micro USB connector but standard micro fit well, and if you make top part with fillament that allows some light pass through you can see on most models with led around even charge status throuh.