wireless charger

Wireless charger base for smartphones. Designed for the Iphone X, but most QI smartphones fit.

Print with support.

Print all the pieces except the "patin" with your normal material, and get this cheap induction coil :

- https://www.gearbest.com/chargers-cables/pp_662438.html?wid=1433363

The charger was made for this specific coil, but another one with similar dimensions should work.

Remove the printing support, pass the coil's circuit board through the slit at the back, and place it inside the lower part of the base. Adjust it to get the charger in place.
Then, position the coil in it's place, and glue it.

Once the elements of the induction coil are in the desired position, place the covers. Make sure to use screws to fix the one at the bottom.

Finally, print the "Patin" with TPU material, and glue the piece under the base.
If you don't have TPU, you can get these cheap pads for a better experience :

- https://www.amazon.fr/gp/product/B00YU2HRTG/ref=ppx_yo_dt_