Wireless charging phone stand

I did not find a suitable model to fit the 84 mm cheapo wireless charger, so I made one. If I remember correctly, this is the Goji 5 W wireless charger. This should work with an 84 mm cheap wireless qi charger with edges that are chamfered. Has a cable guide for the cable. The phone sits at around 75 degrees upright, fits phones less than about 11 mm thick.  This is printed in two pieces, one bottom part where you put the cable and slot the charger into, and the top part to close it off. The top part is not designed to be removed multiple times, so repeatedly taking it apart is not recommended; the tabs holding it together could break. Print with any material, it should work with whatever you want to use. For supports, the cable guide is recommended to have small support, maybe also the top part, depending on the orientation and printer/settings.  Filament consumption is around 65 g. Thank you for all the support! If you like this model, check out the other designs I’ve created on my profile. You can also buy me a virtual coffee to help fuel my filament addiction: buymeacoffee.com/ApuPrints. Find all my socials here: linktr.ee/apuprintsolutions