Thingiverse
Wireless Headtracker
von DarKHawK
68
Downloads
56
Likes
1
Makes
In my case I used code by Cliff from https://github.com/dlktdr/HeadTracker.
Settings are D3 for reset center
The design is based off https://www.thingiverse.com/thing:4744102 by ysoldak who also did original wireless code.
To create the LED ports, I used 4mm lengths or 1.75mm filament.
1 self tapping screw is designed to hold 3.5mm power cable in place, test for shorts before powering on.
Omron style 6x6mm tactile switch is designed to fit in without need for soldering.
Just power needs to be soldered onto nano.
21/01/2022
Changed license from Creative Commons - Attribution - Non Commercial to Creative Commons - Attribution as its been used commercially with donations to Cliff which I support,
Settings are D3 for reset center
The design is based off https://www.thingiverse.com/thing:4744102 by ysoldak who also did original wireless code.
To create the LED ports, I used 4mm lengths or 1.75mm filament.
1 self tapping screw is designed to hold 3.5mm power cable in place, test for shorts before powering on.
Omron style 6x6mm tactile switch is designed to fit in without need for soldering.
Just power needs to be soldered onto nano.
21/01/2022
Changed license from Creative Commons - Attribution - Non Commercial to Creative Commons - Attribution as its been used commercially with donations to Cliff which I support,
Hast du dieses Modell gedruckt? Einloggen und dein Make teilen!
Melde dich an, um einen Kommentar zu hinterlassen
AnmeldenNoch keine Kommentare – sei der Erste!