Thingiverse
Wiring Guide.
por danskinn
10
Descargas
9
Likes
0
Makes
Bolt on if you want to add to existing printed part or built in if you haven't printed it yet.
Bolt on version will require an M3 x 12 or 14mm long nema screw and if you lay the part with the big hole down, it will be stronger than the integrated version. This along with Coolreactions http://www.thingiverse.com/thing:783678 cap should make for a nice install.
P.S. Why is every one installing the motors with the wires comming out the side and not up?
Bolt on version will require an M3 x 12 or 14mm long nema screw and if you lay the part with the big hole down, it will be stronger than the integrated version. This along with Coolreactions http://www.thingiverse.com/thing:783678 cap should make for a nice install.
P.S. Why is every one installing the motors with the wires comming out the side and not up?
¿Has impreso este modelo? Inicia sesión y comparte tu make.
Inicia sesión para dejar un comentario
Iniciar sesiónAún no hay comentarios – ¡sé el primero!