Witcher 3 Wolf Pendant String Lamp

The iconic Witcher 3 wolf medallion. The pendant is held in place with fine strings, giving it the appearance of floating in mid-air. Illumination is provided from both the top and bottom using an integrated RGBW puck, allowing for customizable ambient lighting that highlights the pendant’s sharp contours and metallic finish.   The eyes of the wolf can be independently illuminated, either with a discrete LED module for a constant glow, or via a single white magnetic control switch (such as the MakerWorld KC015) inserted in the back, enabling simple on/off control with a satisfying magnetic swipe.        For minimal supports, the teeth are printed separately. Glue them in BEFORE you glue it together, dont do as I do…  The holes for the magnetic control switch are a bit too large, because if too snug, you might break the strings when handling it.    Any issues or suggestions, shoot me a message Do not use cold plates or excessive glue, taking the print off may damage the strings. Most models with strings only use a single 0.24 layer high string, I use two. That way, if one fails, the other usually does not. The visual is pretty much the same.   To light it you will need the standard 3AAA RGBW pucks, either from Aliexpress or bambu lab.  Here is a link from a seller I used before, you get 3 pucks for a euro - Search “rgbw pucks aaa” on aliexpress and pick the best deal for you. It shouldnt cost more than a euro each The magnetic switches are 8mm, so these should fit. If the link is broken, search: led switch magnetic 8mm Relatively simple, assemble the two halves using an assembly jig in the profile, it is basically two rings that will fit exactly to the two halves, just make sure you put a paper down so the glue doesn't leak and ruin your table (ask me how I know). There are nubs in the provided bases and it will keep it in place for a desktop stand, but carrying it around without gluing it, is not advised… if you are happy with it and do not wish to reuse the base fo