Thingiverse
Witcher Hitcher 1
von Drewed
1k
Downloads
690
Likes
3
Makes
A slide in receiver / Hitch plug. Fits a 2" receiver.
CAUTION!!! This hangs below the receiver. If your receiver tends to scrap when you leave a parking lot, this will get smashed.
I printed in PLA, but I live in WI. It doesn't get all that hot up here.
CAUTION!!! This hangs below the receiver. If your receiver tends to scrap when you leave a parking lot, this will get smashed.
I printed in PLA, but I live in WI. It doesn't get all that hot up here.
Hast du dieses Modell gedruckt? Einloggen und dein Make teilen!
Melde dich an, um einen Kommentar zu hinterlassen
AnmeldenNoch keine Kommentare – sei der Erste!
