Thingiverse
Wiz motion sensor holder
door Ehippi
0
Downloads
0
Likes
0
Makes
Holder with built-in magnets to get Wiz motion sensor to hold on metal objects. I used four 18mm wide and 5mm thick magnets but you can use smaller ones too.
Check the print settings below if you had never used print-in magnets before!
Check the print settings below if you had never used print-in magnets before!
Heb je dit model geprint? Inloggen en deel je make!
Log in om een reactie achter te laten
InloggenNog geen reacties – wees de eerste!
