Thingiverse
Wizzy holder ( E Cig )
door tanosky
1
Downloads
0
Likes
0
Makes
A clip in holder for my vaper "Wizzy" http://www.insmoke.ch/2016/05/06/insmoke-wizzy/
The cutouts are designed to grab the device and remove it from the holder.
the middle section is quite thin, so using it without it being screwed to any surface may split it in half.
I might redesign it in the future
The cutouts are designed to grab the device and remove it from the holder.
the middle section is quite thin, so using it without it being screwed to any surface may split it in half.
I might redesign it in the future
Heb je dit model geprint? Inloggen en deel je make!
Log in om een reactie achter te laten
InloggenNog geen reacties – wees de eerste!