Thingiverse
WLED matrix 8x10
by BananaManana
0
Downloads
1
Likes
0
Makes
Hey there!
I designed my own 8X10 LED matrix.
I wanted to give it a DIY look, so there is no backplate to hide the wires and the WLED board.
The control box is glued in place (in case you are using a different box) and held with double-sided tape.
Four M3x16 screws are needed to close the box.
I use WLED to control the LEDs. Let me know if you would like me to upload the 2D matrix configuration.
You need to print "feet" 2 times. It helps the box to stand.
I designed my own 8X10 LED matrix.
I wanted to give it a DIY look, so there is no backplate to hide the wires and the WLED board.
The control box is glued in place (in case you are using a different box) and held with double-sided tape.
Four M3x16 screws are needed to close the box.
I use WLED to control the LEDs. Let me know if you would like me to upload the 2D matrix configuration.
You need to print "feet" 2 times. It helps the box to stand.
Did you print this model? Sign in and share your make!
Sign in to leave a comment
Sign inNo comments yet – be the first!
