Wobbly Snowman

Snowman wobble figure. Everything printed in parts and assembled - no ACE required.   Parts Glue and weights of your choice: Copper coated BBs Copper bearings Tungsten bearings Instructions The placement of the eyes and buttons should match how they should be placed on the snowman. Position the eyes, nose, mouth, and buttons through the bottom from the inside and press firmly. They should pop snugly in place without any glue. The colored ring around the hat requires a small amount of glue to hold in place. The hat will also require a little glue to attach to the body The two halves of the scarf will also require a small amount of glue to attach around the neck. Place some loose change or other weights of your choice on the inside of the base of the wobble figure. You may want to pack in some paper towels, cotton rounds, or other material to fill the remaining space and keep the weights from shifting. Ideally they should be held towards the bottom/center of the base. Press the circular cover over the weights and press the edges to snap it place. Install the base into the body.