Wolf & Diamond

Artwork source/Author: Kathryn Diane Nicholson Booth Print at 100% infill with a layer height of 0.08mm with a base layer of 0.16mm. Or you can only modify the X and Y dimensions. Do not adjust the height (Z) in your slicer! The layers would not be correct. You may print at higher layer heights below the Min Depth of 0.48mm. The Max Depth is 2.16mm and the Actual Depth is 2.16mm.   These were my settings and colors for my print that you see in the picture. Your results may be depending on the filament you use. Filaments Used: PLA Elegoo + Black Transmission Distance: 0.3 PLA Sunlu META Grey Transmission Distance: 3.6 PLA Elegoo + Gray Transmission Distance: 3 PLA Elegoo + White Transmission Distance: 6 This print uses 4 unique filaments   Swap Instructions:     Start with Black     At layer #8 (0.72mm) swap to Grey     At layer #13 (1.12mm) swap to Gray     At layer #17 (1.44mm) swap to White for the rest.