Thingiverse
Wolf Head Accessories
von Da5hau
159
Downloads
106
Likes
0
Makes
Some Wolf head options, I made up for my Wolfspear's.
Print at 90-95% for Original, (you will need to test this on your set up)
You may need to trim to fit your figures, especially over the shoulders. (The clippers are good for this).
I use a heat gun and hold the item in tweezers. when it gets soft I mould it to the figure, hold till cold and then glue to the figure. (A bonus is you can easily sculpt the cloak to fit and add folds).
Print at 90-95% for Original, (you will need to test this on your set up)
You may need to trim to fit your figures, especially over the shoulders. (The clippers are good for this).
I use a heat gun and hold the item in tweezers. when it gets soft I mould it to the figure, hold till cold and then glue to the figure. (A bonus is you can easily sculpt the cloak to fit and add folds).
Hast du dieses Modell gedruckt? Einloggen und dein Make teilen!
Melde dich an, um einen Kommentar zu hinterlassen
AnmeldenNoch keine Kommentare – sei der Erste!
