Thingiverse
Wolf Head Shift Knob
von Screwyluie
285
Downloads
367
Likes
3
Makes
Remade this as shift knob for my '05 Nissan Sentra SER Spec-V
update: cut the head off and gave it supports as well as alignment holes. Now there's a top with holes and a bottom with holes and a peg (you'll need two) to put them together. The supports are decent, mine needed a little bit of file work after removal so everything was smooth to the touch. took about 5 minutes. The alignment of the pegs/top/bottom is perfect. I'm quite happy with it. It's much easier to print and the finish quality is much higher in a vertical alignment. Oh yeah and in the two piece version I pinned his ears back because they were rubbing the palm of my hand raw. Now it is much nicer to use.
update: cut the head off and gave it supports as well as alignment holes. Now there's a top with holes and a bottom with holes and a peg (you'll need two) to put them together. The supports are decent, mine needed a little bit of file work after removal so everything was smooth to the touch. took about 5 minutes. The alignment of the pegs/top/bottom is perfect. I'm quite happy with it. It's much easier to print and the finish quality is much higher in a vertical alignment. Oh yeah and in the two piece version I pinned his ears back because they were rubbing the palm of my hand raw. Now it is much nicer to use.
Hast du dieses Modell gedruckt? Einloggen und dein Make teilen!
Melde dich an, um einen Kommentar zu hinterlassen
AnmeldenNoch keine Kommentare – sei der Erste!
