Cosplay STL Download - Wolf Masquerade Maskby Perihelion Prints

Wolf (Canine) Masquerade Mask, by Perihelion PrintsReady to print and wear or display.======This mask, with canine ears and a snout, is perfect for a masquerade party, as part of a wolf or fox cosplay, or for a performance costume. Scaled to fit most adult heads.For attachment to head, use elastic cord or ribbon. For fitting, place the mask on your face, lining it up with your eyes and the sides of your face. It should cover your nose, down to about the top of your mouth.Measure how much ribbon you'll need to go around your head, then add a bit more and cut two equal halves. Tie a knot at the end of each piece of cord, or glue one to each side of the mask, and use the leftover length to tie both pieces into a knot/bow behind or head. Or you can edit the file to come up with your own solution.You may also want to put a piece of foam on the sides of the mask, so it doesn't hurt the sides of your face. And be careful not to poke yourself with the eyeholes, which protrude inwards. Placing piece of foam in the middle of the forehead section of the mask may help.Sculpted in Blender. STL included. Dimensions in millimetres.======0.20mm layer height recommended.Use supports where appropriate - organic supports recommended. Brim also recommended. Print upright for best results.15% infill tested. PLA recommended.Filament Usage (estimated): 155gPrinting Time (estimated): 21h 30m^ Estimates based off slicing for Prusa MK3.9. Your mileage may vary.