Thingiverse
Wolf Pumpkin
von mdelapa
46
Downloads
54
Likes
0
Makes
Perfect for around the house, or working in an office where desk space is limited.
I printed at 0.2mm layer heights and 5% infill with supports and at 1500% infill.
Depending on scale, it can fit a LED candle. Do NOT use a real flame within it.
If you appreciate the work I do, please consider adding this thing to your favorites, and sharing.
When it comes to removing the support, I found a pair of thin needle nosed pliers worked pretty well, just go slowly as the wolf is somewhat delicate.
I printed at 0.2mm layer heights and 5% infill with supports and at 1500% infill.
Depending on scale, it can fit a LED candle. Do NOT use a real flame within it.
If you appreciate the work I do, please consider adding this thing to your favorites, and sharing.
When it comes to removing the support, I found a pair of thin needle nosed pliers worked pretty well, just go slowly as the wolf is somewhat delicate.
Hast du dieses Modell gedruckt? Einloggen und dein Make teilen!
Melde dich an, um einen Kommentar zu hinterlassen
AnmeldenNoch keine Kommentare – sei der Erste!
