Woobu Koneko

✨ Woobu Koneko ✨ Assembly video - Youtube shorts 3 walls, 15% gyroid or 3D honeycomb infill. No supports. The print in place version tested down to 50% I don't recommend going below 70% for the split to parts version Use 0.12 Layer height for best quality on everything except the body which can be printed with standard 0.2 layer height Use Concentric pattern for top surface pattern Split to parts version tested up to 120%, I don't recommend scaling this version down Please use Brims with a brim gap of 0.3 if you are using Textured PEI plate, especially so if its a multi color plate. A little bit of post printing clean up is better than losing the plate due to adhesion issues. For the split to parts version tolerance can vary across printers and filaments, Scaling up or down 2% depending on your fit should resolve any assembly issues. If you need to scale the face make sure you are also scaling the rest of the face parts with t