Thingiverse
Working Clamp
von liambrown
2
Downloads
0
Likes
0
Makes
My first attempt at making a one-print moving part.
I found it works well at 0.2mm layer height. It'll take some moving to finally break it free but it does open all the way up eventually with a bit of working.
Use standard settings for whatever material you are using, although I have only tested this in PLA.
Use supports everywhere unless you can do amazing overhangs ;)
----------
This thing was made with Tinkercad. Edit it online https://www.tinkercad.com/things/9XXTc67kDhZ
I found it works well at 0.2mm layer height. It'll take some moving to finally break it free but it does open all the way up eventually with a bit of working.
Use standard settings for whatever material you are using, although I have only tested this in PLA.
Use supports everywhere unless you can do amazing overhangs ;)
----------
This thing was made with Tinkercad. Edit it online https://www.tinkercad.com/things/9XXTc67kDhZ
Hast du dieses Modell gedruckt? Einloggen und dein Make teilen!
Melde dich an, um einen Kommentar zu hinterlassen
AnmeldenNoch keine Kommentare – sei der Erste!