Working wand

This is a working magic wand! This wand can shoot confetti foam, paper, and anything else you can think of! You will need 3 rubber bands, but any rubber bands will work printing:I printed this model in Pla with 20% infill, I recommend not going bellow 20%For the “wand body” I made sure to print it vertically with tree supports AssemblyI am going to refer to the parts from now on as they are listed in the downloads If you are going to paint the wand do it before the assembly :)To start the assembly place the "firing mechanism rev 3" into its slot in the “wand body” as shown in the images. Now place a REAL toothpick through that hole and clip the ends. ( if you do not have a real toothpick use the “toothpick fake” file)Next place a rubber band onto the extrusions “firing mechanism rev 3” on the “wand body” figure eight the rubber band on place it onto the cylinder on top of “firing mechanism rev 3” now figure eight again and place the rubber band on the extrusion on the other sid