Working Water Wheel & Mill

DISCLAIMER: I designed this for my wife and never intended to release it to Thingiverse. I got so many people asking for it on Reddit that I went back in and made some design improvements for you. If you find a better way to do something, try it!Video: https://www.reddit.com/r/CR10/comments/c0d8o6/designed_and_printed_on_a_cr10_pro/Use discretion when selecting layer heights. Most parts can be low resolution (0.2) but the pump, impeller and hose nozzles should do better around 0.08.You may want to experiment with impeller designs as I am still trying to quiet the pump down. Its possible my motor just allows too much shaft movement and the impeller pulls itself into the face plate. Still works, just a bit louder than I want.Be sure to seal the pond after painting. I tried outdoor clear flat but it still soaked up some water. I have since painted clear resin over the painted and detailed pond bottom.If your wall support pegs result in a tight fit due to your printer settings, carefully s