Thingiverse
Workmate removable jaw
by dewexdewex
35
Downloads
20
Likes
0
Makes
This is a replacement vice jaw for use on Black and Decker Workmate folding work benches. It is designed to fit the 20mm approx. dia. holes in these benches.
The design is asymmetric to enable it to print without support.
The tab on the jaw, which facilitates removal from the bench, is on one side of the jaw only and is accentuated to make this easier.
If the locking tabs make the jaw too tight, please sand them down until a better fit is established.
The design is asymmetric to enable it to print without support.
The tab on the jaw, which facilitates removal from the bench, is on one side of the jaw only and is accentuated to make this easier.
If the locking tabs make the jaw too tight, please sand them down until a better fit is established.
Did you print this model? Sign in and share your make!
Sign in to leave a comment
Sign inNo comments yet – be the first!