Thingiverse
Workpiece Clamps
por jack0088
3
Descargas
6
Likes
0
Makes
Print the handle once.
Print at least two or more pairs of the pivot + wedge.
Print at least three or more edge support pins.
Stick the pivot into the wedge. Plug the pivot then into a workbench hole (my workbench has 20mm holes in diameter, at a matrix of 96x96mm) and use the handle to tighten or loose the clamp to fixate your workpiece in place.
Print at least two or more pairs of the pivot + wedge.
Print at least three or more edge support pins.
Stick the pivot into the wedge. Plug the pivot then into a workbench hole (my workbench has 20mm holes in diameter, at a matrix of 96x96mm) and use the handle to tighten or loose the clamp to fixate your workpiece in place.
¿Has impreso este modelo? Inicia sesión y comparte tu make.
Inicia sesión para dejar un comentario
Iniciar sesiónAún no hay comentarios – ¡sé el primero!
