Thingiverse
Workshop Modified Saber Wall Mounts
door TCotant
13
Downloads
7
Likes
0
Makes
I modified this to fit my workshop saber:
1) Cut a hole in the base so the D-ring could fit
2) Angled the bottom base *toward* where the wall will be, so it didn't lean forward anymore. This tends to keep the blade in the ring holder easier (mine actually stayed in the holder, even before using the blade ring).
3) Cut a slot in the blade holder so the blade comes out easier (without having to slide it out of the bottom of the holder - it can easily go through it.
1) Cut a hole in the base so the D-ring could fit
2) Angled the bottom base *toward* where the wall will be, so it didn't lean forward anymore. This tends to keep the blade in the ring holder easier (mine actually stayed in the holder, even before using the blade ring).
3) Cut a slot in the blade holder so the blade comes out easier (without having to slide it out of the bottom of the holder - it can easily go through it.
Heb je dit model geprint? Inloggen en deel je make!
Log in om een reactie achter te laten
InloggenNog geen reacties – wees de eerste!
