Thingiverse
Wound Tracker
von Half_Cut
315
Downloads
169
Likes
3
Makes
This thing was made with Tinkercad. Edit it online https://www.tinkercad.com/things/bCcs3GoZ8Gf
Keep track of wounds on your larger units. Two dials count from 29 to 0
Originally designed to have the pin glued in place I find just dry fitting it holds all the parts in place as if by magic, so don't fit the pin until you are happy.
Should be a tight fit but turn easily.
If you get the first layer spreading a little, run a mold line remover around the bottom edge of the holes.
Keep track of wounds on your larger units. Two dials count from 29 to 0
Originally designed to have the pin glued in place I find just dry fitting it holds all the parts in place as if by magic, so don't fit the pin until you are happy.
Should be a tight fit but turn easily.
If you get the first layer spreading a little, run a mold line remover around the bottom edge of the holes.
Hast du dieses Modell gedruckt? Einloggen und dein Make teilen!
Melde dich an, um einen Kommentar zu hinterlassen
AnmeldenNoch keine Kommentare – sei der Erste!
