Thingiverse
Woven Ball
door DaveMakesStuff
385
Downloads
361
Likes
0
Makes
This Woven Ball is impossible to print. Unless you use water soluble PVA filament for supports!
See here for video: https://youtu.be/o5lJ5TMQRpk
See here for stable download: https://than.gs/m/900636
The top inside of the ball has overhangs that need to be supported or the print will fail. Typical supports can’t be use because the holes are too small to allow removal of supports from inside the ball. With PVA filament, you can use all the supports you need, soak the finished print in warm water, and watch the supports simply dissolve away!
This model printed with my Snapmaker J1 IDEX printer using Snapmaker PVA filament and Sunlu White PLA.
See here for video: https://youtu.be/o5lJ5TMQRpk
See here for stable download: https://than.gs/m/900636
The top inside of the ball has overhangs that need to be supported or the print will fail. Typical supports can’t be use because the holes are too small to allow removal of supports from inside the ball. With PVA filament, you can use all the supports you need, soak the finished print in warm water, and watch the supports simply dissolve away!
This model printed with my Snapmaker J1 IDEX printer using Snapmaker PVA filament and Sunlu White PLA.
DaveMakesStuff publiceert ook op
7 extra modellen op 1 andere platforms
Heb je dit model geprint? Inloggen en deel je make!
Log in om een reactie achter te laten
InloggenNog geen reacties – wees de eerste!