Thingiverse
WPL front RX-ESC Holder
von BlackVenom
21
Downloads
9
Likes
0
Makes
Front holder base: Matches up w/ the 3 posts on the stock front end where the rx/esc and battery holder were.
Top piece has cut outs for esc and rx, routing holes for wires.
ESC/RX cut outs are roughly:
24*45mm (w/ hole for antenna) designed for FlySky FS-GR3E
21*45mm (cheap 10-20w ESC)
Top piece has cut outs for esc and rx, routing holes for wires.
ESC/RX cut outs are roughly:
24*45mm (w/ hole for antenna) designed for FlySky FS-GR3E
21*45mm (cheap 10-20w ESC)
Hast du dieses Modell gedruckt? Einloggen und dein Make teilen!
Melde dich an, um einen Kommentar zu hinterlassen
AnmeldenNoch keine Kommentare – sei der Erste!
