Thingiverse
Wrench Organizers
von domoaffogato
2.5k
Downloads
1.3k
Likes
1
Makes
Magnets used are 12 x 3 mm and attached using superglue (I highly recommend BSI InstaCure with accelerant). The only 2 holders in the picture not 3D printed are from Ernst (and are bigger than my print bed).
Hast du dieses Modell gedruckt? Einloggen und dein Make teilen!
Melde dich an, um einen Kommentar zu hinterlassen
AnmeldenNoch keine Kommentare – sei der Erste!