Thingiverse
Wrist RFID Holder
por kn4abb
3
Descargas
2
Likes
0
Makes
RFID holder to use with an 18mm NATO strap.
I had to clean the strap hole up some after printing, but I think think that had more to do with bad bridging due to my settings.
After a bit over a year of use and snagging on things it has started cracking on the bottom part of the strap hole, but is otherwise holding up fine.
I had to clean the strap hole up some after printing, but I think think that had more to do with bad bridging due to my settings.
After a bit over a year of use and snagging on things it has started cracking on the bottom part of the strap hole, but is otherwise holding up fine.
¿Has impreso este modelo? Inicia sesión y comparte tu make.
Inicia sesión para dejar un comentario
Iniciar sesiónAún no hay comentarios – ¡sé el primero!