Thingiverse
WRLS (Water Rocket Launch System)
door Superbeasti
6.4k
Downloads
4.7k
Likes
5
Makes
So, I heard NASA is looking for contractors to take Things to space, so why not print your own rocket launch system!
For more rocketry, check the whole collection here
This thing is a water rocket, which can be fully 3D printed using using the 19x2mm TPU seal and the Inlet_Metric, or use store bought O-rings, sizes below:
Inlet_Metric O-ring
19mm (inner diameter) 2mm cross section
Inlet_Imperial O-Ring
3/4" (inner diameter) 1/16" cross section
To adjust the release tightness, you can scale the printable O-ring or the pin, as pictured in the gallery.
There's two options for fixing the launcher in place:
Mount_Heavy_Duty is fixed directly to something solid (wood etc.)
Mount and Leg_Peg for removable use, to ground or sand.
Assembly instructions below. All parts should be printed with 100% infill and with 0.2 layer height for optimal clearance between parts.
1 Print all parts and get the hardware if you decide to use the actual valves and O-Rings
For more rocketry, check the whole collection here
This thing is a water rocket, which can be fully 3D printed using using the 19x2mm TPU seal and the Inlet_Metric, or use store bought O-rings, sizes below:
Inlet_Metric O-ring
19mm (inner diameter) 2mm cross section
Inlet_Imperial O-Ring
3/4" (inner diameter) 1/16" cross section
To adjust the release tightness, you can scale the printable O-ring or the pin, as pictured in the gallery.
There's two options for fixing the launcher in place:
Mount_Heavy_Duty is fixed directly to something solid (wood etc.)
Mount and Leg_Peg for removable use, to ground or sand.
Assembly instructions below. All parts should be printed with 100% infill and with 0.2 layer height for optimal clearance between parts.
1 Print all parts and get the hardware if you decide to use the actual valves and O-Rings
Superbeasti publiceert ook op
21 extra modellen op 3 andere platforms
Heb je dit model geprint? Inloggen en deel je make!
Log in om een reactie achter te laten
InloggenNog geen reacties – wees de eerste!