Thingiverse
WWR Armstrong
by 2ndThought
30
Downloads
23
Likes
1
Makes
This is my effort, as a fan, to reproduce the Armstrong robot from Ashley Wood and TP Louise's WWR universe. This is not a snap-fit, posable model. Printing out these parts will allow you to build a static model in a pose of your choosing.
Design
I tried to use peg-and-hole connections where they made sense, otherwise it's just glue in place. Tolerances are 0.2-0.3 mm. I also tried to orient the model parts on the printing bed to reduce the need for supports but some support is still required. Use your discretion. Assembly relies on common sense. Please refer to the example pictures for guidance. Fully assembled the model should stand just under 20 cm at current scale.
Parts Notes
- Arms: each arm can be left or right; upper arm glues directly to shoulder ball joint; see assembled picture
- Body: two parts: simply glue together
- Dome: glue directly to head once eye is in place
- Exhaust port: glue directly to front recess in lower body
- Eye: two parts: simply glue tog
Design
I tried to use peg-and-hole connections where they made sense, otherwise it's just glue in place. Tolerances are 0.2-0.3 mm. I also tried to orient the model parts on the printing bed to reduce the need for supports but some support is still required. Use your discretion. Assembly relies on common sense. Please refer to the example pictures for guidance. Fully assembled the model should stand just under 20 cm at current scale.
Parts Notes
- Arms: each arm can be left or right; upper arm glues directly to shoulder ball joint; see assembled picture
- Body: two parts: simply glue together
- Dome: glue directly to head once eye is in place
- Exhaust port: glue directly to front recess in lower body
- Eye: two parts: simply glue tog
Did you print this model? Sign in and share your make!
Sign in to leave a comment
Sign inNo comments yet – be the first!
