Thingiverse
Wyrm (dragon)
von EagleKitty
6
Downloads
3
Likes
0
Makes
Ew old model yuck
Hello! Thanks for clicking on this model! It's sort of old, and I honestly don't think it looks very good. If you want a better, newer dragon model of mine, check out this one! https://www.thingiverse.com/thing:5460725
ROAR!
A mighty dragon, ready to print!
(Well, I think so. There might be problems with the mesh, and I cannot run a test print, as my 3D printer is not working. Please comment if you find any problems with the mesh, and I will try to fix it.)
Also, I know that the claws look horrible. Claws are hard.
As I previously stated, my 3D printer is not working, so I am just assuming the print settings.
Hello! Thanks for clicking on this model! It's sort of old, and I honestly don't think it looks very good. If you want a better, newer dragon model of mine, check out this one! https://www.thingiverse.com/thing:5460725
ROAR!
A mighty dragon, ready to print!
(Well, I think so. There might be problems with the mesh, and I cannot run a test print, as my 3D printer is not working. Please comment if you find any problems with the mesh, and I will try to fix it.)
Also, I know that the claws look horrible. Claws are hard.
As I previously stated, my 3D printer is not working, so I am just assuming the print settings.
Hast du dieses Modell gedruckt? Einloggen und dein Make teilen!
Melde dich an, um einen Kommentar zu hinterlassen
AnmeldenNoch keine Kommentare – sei der Erste!
